D-Link WiFi range extenders have become popular among netizens due to their unparalleled networking speeds. All they do is fetch the WiFi signal from the router, amplify it, and transmit it into the areas that are hard to wire. Users can install their D-Link range extenders by accessing dlinkap.local. However, a few users have reported facing problems using their amplifying devices. They state that their D-Link extender is not giving full speed.
In case you are also experiencing similar kinds of problems that are stopping you from making the most out of your range extenders, this is the post you must check out. Here, we have stated the hacks that will help you address the issue like it never existed in the place. Stick to reading.
Fixed: D-Link Extender Not Giving Full Speed
Check the Hardwired Connection
The primary reason stopping you from getting 100% from your range extender is a loose hardwired connection between your networking devices. Perhaps, the LAN cable connecting your devices is not properly fitted. Also, you cannot overlook the probability of damage on the cable. Therefore, have a look at the connection and verify both the factors that we’ve discussed above. In case the cable is weary, you should make use of a new one. Be very certain that the connection is nowhere close to loose. Also, the cable must be joining the correct ports (the extender’s internet port and the router’s LAN1 port).
Relocate the Extender
The extender’s location plays a pivotal role when it comes to extracting its best performance. Know that the range extender never performs optimally when it is placed in a congested space. This is because the WiFi signals emitted by it get obstructed before reaching the final destination. Thus, you are required to make changes to the location of the range extender. Ensure that you are placing it in an open, clean, and well-ventilated space. Apart from this, the place must not be housing any heavy electrical appliances and objects that contain a lot of water. Avoid placing the extender close to metal objects and shiny surfaces.
Upgrade the Firmware
The next thing you can do in order to fix the D-Link extender not giving full-speed issues is to upgrade the firmware. It has been noticed that some users keep using their devices on obsolete firmware due to which they are unable to take advantage of the latest features that arrive with a firmware update. So, you must upgrade the WiFi range extender’s firmware without any delay. The default web address dlinkap local will help you get through the process. Make sure that you upload the correct firmware file on your range extender and do not interrupt the process by making unnecessary tweaks.
Restart the Extender
The importance of power cycling can never be neglected in the technical realm. It has always worked wonders in resolving various issues related to other networking devices. Perhaps, the one in the discussion will also get fixed by a simple power cycle of the range extender. Therefore, it is advised that you plug out the WiFi router first and then your wireless extender. Now, after waiting for a decent gap of at least 40 minutes, connect the devices back to their respective wall outlets in the same manner as you powered them down. Just in case you do not notice any improvement in the performance of your range extender, you can head over to reconfigure it.
Last But Not Least
As we’ve mentioned earlier if you are still unable to make the most of your WiFi device, you should look forward to resetting it. Thus, wait for nothing and reset the range extender. For this, the Reset button located in the hole with the same label will help you. All you need to do is push it gently with the help of a pointed object. The button needs to be pressed for at least 30 seconds. Thereafter, set it up again using the default address.
